site map / search / help  
Home Page   Products Support Downloads Dealers What's New
Support:
 
Press Room:
 
Help:
Troubleshooting Guides: AH-2, AH-3 and AT-120
Symptom: Won't start tuning.
Probable Cause: Faulty regulator.
Cure: Replace faulty IC9 8-volt regulator chip.

Symptom: Won't start tuning.
Probable Cause: Start line goes low, but key line remains high.
Cure: Replace faulty Q2, Q3, or Q4 transistors.

Symptom: Won't tune on some bands.
Probable Cause: Faulty IC10, IC11, or IC12 chips.
Cure: Replace faulty ICs.
Remarks: Check resistor-cap pairs next to relays for signs of overheating.

Symptom: In AH2 controller: "TUNE" and "THRU" LEDs don't work.
Probable Cause: Faulty IC1 chip and/or IC2 5-volt regulator.
Cure: Replace defective parts.

go back

 

 

All contents ©1996-2003 Icom America Inc. The Icom logo is a registered trademark of Icom Inc. Terms of use.